Planet IP30 Industrial L3 8-Port 10/100/1000T+ 8-port 1G/2.5G SFP Full Switch Kupferdraht 0,1 Gbps ARP BOOTP DHCP DNS HTTP IPv6 NTP RMON SMTP SNMP TCP/IP Telnet UDP Duplex Voll-Duplex Ethernet RS-232 RJ-45 Managed

Planet IP30 Industrial L3 8-Port 10/100/1000T+ 8-port 1G/2.5G SFP Full Switch Kupferdraht 0,1 Gbps ARP BOOTP DHCP DNS HTTP IPv6 NTP RMON SMTP SNMP TCP/IP Telnet UDP Duplex Voll-Duplex Ethernet RS-232 RJ-45 Managed

Produktbeschreibung:

8 10/100/1000BASE-T RJ45 copper ports 8 100/1000BASE-X
SFP slots for SFP type auto detection One RJ45-to-RS232
console interface for basic management and setup
  Industrial Hardened Design: Dual power input,
redundant power with reverse polarity protection
DC 12 to 48V input or AC 24V input Active-active
redundant power failure protection Backup of catastrophic
power failure on one supply Fault tolerance and
resilience DIN-rail and wall-mountable designs
IP30 aluminum case Supports 6000V DC Ethernet
ESD protection -40 to 75 degrees C operating temperature
  Digital Input and Digital Output: 2 Digital
Input (DI) 2 Digital Output (DO) Integrates sensors
into auto alarm system Transfers alarm to IP network
via email and SNMP trap   Layer 3 IP Routing Features:
IP dynamic routing protocol supports OSPFv2 IPv4/IPv6
hardware static routing Routing interface provides
per VLAN routing mode   Layer 2 Features High
performance of Store-and-Forward architecture,
and runt/CRC filtering eliminates erroneous packets
to optimize the network bandwidth Storm control
support Broadcast/Multicast/Unknown unicast Supports
VLAN IEEE 802.1Q tagged VLAN Up to 255 VLANs groups,
out of 4095 VLAN IDs Supports provider bridging
(VLAN Q-in-Q IEEE 802.1ad) Private VLAN Edge (PVE)
Protocol-based VLAN MAC-based VLAN Voice VLAN
GVRP (GARP VLAN Registration Protocol) Supports
Spanning Tree Protocol IEEE 802.1D Spanning Tree
Protocol (STP) IEEE 802.1w Rapid Spanning Tree
Protocol (RSTP) IEEE 802.1s Multiple Spanning
Tree Protocol (MSTP),
spanning tree by VLAN BPDU Guard Supports Link
Aggregation 802.3ad Link Aggregation Control Protocol
(LACP) Cisco ether-channel (static trunk) Maximum
14 trunk groups,
with 16 ports for each trunk Up to 80Gbps bandwidth
(full duplex mode) Provides port mirror (many-to-1)
Port mirroring to monitor the incoming or outgoing
traffic on a particular port Loop protection to
avoid broadcast loops Link Layer Discovery Protocol
(LLDP) Compatible with Cisco uni-directional link
detection(UDLD) that monitors a link between two
switches and blocks the ports on both ends of
the link if the link fails at any point between
the two devices Supports G.8032 ERPS (Ethernet
Ring Protection Switching) IEEE 1588 and Synchronous
Ethernet network timing   Quality of Service:
Ingress shaper and egress rate limit per port
bandwidth control 8 priority queues on all switch
ports Traffic classification IEEE 802.1p CoS ToS/DSCP/IP
Precedence of IPv4/IPv6 packets IP TCP/UDP port
number Typical network application Strict priority
and Weighted Round Robin (WRR) CoS policies Traffic-policing
 on the switch port DSCP remarking Voice VLAN
  Multicast: Supports IPv4 IGMP snooping v1,
v2 and v3 Supports IPv6 MLD snooping v1 and v2
Querier mode support IPv4 IGMP snooping port filtering
IPv6 MLD snooping port filtering MVR (Multicast
VLAN Registration)   Security: Authentication
IEEE 802.1X Port-based/MAC-based network access
authentication IEEE 802.1x authentication with
guest VLAN Built-in RADIUS client to cooperate
with the RADIUS servers RADIUS/TACACS+ users access
authentication Guest VLAN assigns clients to a
restricted VLAN with limited services Access Control
List IP-based Access Control List (ACL) MAC-based
Access Control List (ACL) Source MAC/IP address
binding DHCP Snooping to filter distrusted DHCP
messages Dynamic ARP Inspection discards ARP packets
with invalid MAC address to IP address binding
IP Source Guard prevents IP spoofing attacks IP
address access management to prevent unauthorized
intruder   Management: IPv4 and IPv6 dual stack
management Switch Management Interfaces Console
and Telnet Command Line Interface HTTP web switch
management SNMP v1 and v2c switch management SSH,
TLS, SSL and SNMP v3 secure access SNMP Management
Four RMON groups (history,
statistics, alarms, and events) SNMP trap for
interface Link Up and Link Down notification IPv6
IP address/NTP/DNS management Built-in Trivial
File Transfer Protocol (TFTP) client BOOTP and
DHCP for IP address assignment System Maintenance
Firmware upload/download via HTTP Reset button
for system reboot or reset to factory default
Dual Images DHCP Relay DHCP Option 82 DHCP Server
User Privilege levels control Network Time Protocol
(NTP) Network Diagnostic SFP-DDM (Digital Diagnostic
Monitor) Cable diagnostic technology provides
the mechanism to detect and report potential cabling
issues ICMPv6/ICMPv4 remote ping SMTP/Syslog remote
alarm System Log PLANET Smart Discovery Utility
for deployment management    

Technische Details: